Chapter 33-2F-3-83) When you have removed the ADF controller cover, disconnect the con-nector [3] of the ADF controller PCB; then, remove the screw [4], and re-move the grounding wire [5]. Free the harness from the wire saddle [6],and detach the other saddle [7].F-3-94) Remove the four screws [1], and detach the main cover [2].The main cover is fitted with the original tray [3], and cables are connectedto it. Take extra care when removing it not to damage the cables.F-3-103.3 Drive System3.3.1 Reversal Motor3.3.1.1 Removing the Front Cover 0011-82531) Remove the front cover [1].-Three screws [2] (remove)-One screw [3] (loosen)F-3-11F-3-12F-3-133.3.1.2 Removing the Main Cover 0011-82061) Open the upper cover, and insert a screwdriver from above the hook; then,remove the two hooks [1].F-3-142) Free the hook of the pickup assembly cover [2] from the right stay; then,detach it while paying attention to the hooks on the front and rear sideplates.[2]HooksPush. Freed.[5][7][4][6][3][1] [1][1][1][3][2][1][1]
