Chapter 44-18F-4-802) Set the DIP switch (SW1) on the ADF controller PCB as indicated.F-4-813) Place a single sheet [1] of A4 or LTR copy paper in the original tray.F-4-824) Press the push switch (SW2) on the ADF controller PCB once.- A single press on the push switch (SW2) causes the original to be pickedup and stopped on the copyboard glass.F-4-835) Open the ADF slowly, and check to make sure that C shown in the figureis as indicated.T-4-5F-4-846) Close the DADF, and press the push switch (SW2) on the ADF controllerPCB once.- The original will be delivered to the delivery tray.If the Value Is Not As IndicatedIf the value is not as indicated, adjust the position of the original tray.1) Loosen the tray fixing screw, and adjust the position of the original tray.F-4-85If C>3.1 mm for A4 or 11.9 mm for LTR, shift the manual feed tray towardthe rear.If C<3.1 mm for A4 or 11.9 mm for LTR, shift the manual feed tray towardthe front.2) At the end of the adjustment, loosen the original tray fixing screw.3) Set the DIP switch (SW1) on the ADF controller PCB back to its initialsetting, and mount the ADF controller cover.b. Manual Feed Tray Pickup1) Remove the screw [1], and detach the ADF controller cover [2].F-4-862) Set the DIP switch (SW1) on the ADF controller PCB as indicated.F-4-873) Open the manual feed tray, and place a single sheet of A4 or LTR copypaper.- Be sure to butt the copy paper against the rear.F-4-88Original size Value of CA4 3.1±1mmLTR 11.9±1mm[1][2]J1J2J5J3 J6 J7 J8 J9 J10J16 J15J11J14IC8J13J12J4 CB1SW1DSP1SW4SW3SW2COriginalScrewScrewOriginal tray[1][2]Manual feed tray
