Chapter 33-3F-3-153) When you have removed the ADF controller cover, disconnect the con-nector [3] of the ADF controller PCB; then, remove the screw [4], and re-move the grounding wire [5]. Free the harness from the wire saddle [6],and detach the other saddle [7].F-3-164) Remove the four screws [1], and detach the main cover [2].The main cover is fitted with the original tray [3], and cables are connectedto it. Take extra care when removing it not to damage the cables.F-3-173.3.1.3 Removing the Reversal Motor Unit 0011-24441) Disconnect the connector J602 [2] from the reversal motor driver PCB [1].2) Remove the cable [2] from the cable clamp.3) Remove the screw [4], and detach the pre-reversal sensor base [3].F-3-183) Remove the screw [2], and detach the cover [2]; then, remove the twoscrews [3], and detach the reversal motor unit [4].F-3-193.3.2 Pickup Motor3.3.2.1 Removing the Front Cover 0011-92241) Remove the front cover [1].-Three screws [2] (remove)-One screw [3] (loosen)F-3-20F-3-21[2]HooksPush. Freed.[5][7][4][6][3][1] [1][1][1][3][2][1] [2] [3][4][1][4][3][3][2]
