7. AdvancedImage 7-27• Color space : allows to select between 5 different color spaces- RGB- ITU_BT_709- SMPTE_240M- ITU_BT_601- EBU• Clamp position : allows to set the clamp pulse position in the clamping circuit• Clamp width : allows to set the width of clamp pulse in the clamping circuitIt is recommended to use the default values.Advanced settings for Digital Data sources (DVI)The advanced button enables the advanced settings for digital data sources.Image 7-28UsePictureBox can be disabled (0) or enabled (1). By default, it is disabled which means that only few timings can be changed. Incase of a DVI source this is not a problem.In very specific situations however (e.g. iBlend), more changes to the timings may be needed, such as the setting of the Start pixels,Active pixels, Start lines, Active lines. In that case, hit Enter and change the slider to position 1, thus enabling more settings in theEdit file menu.Image 7-297.4.4 Save as (create a custom file)Creating a custom fileWhen the loaded file is a standard file there is a possibility of saving it as a custom file (= creating a custom file) , this is done withthe save as function. The saved file will always be a custom file (saved in the custom directory)For sources that are often used, a custom file should be created. This custom file will then be loaded auto-matically and will prevent the Auto Image from being launched.How to save a file ?1. Press MENU to activate the Tool bar2. Press → to select the Image files item3. Press ↓ to Pull down the Image files menu4. Use ↑ or ↓ to select Save as...R59770330 SIM 7QP SERIES 08/12/2014 65
