5. SetupImage 5-1Barco SIM7 : Power switchL3 and L1 light up red. After the initialization period L1 turns off.Image 5-2Image 5-3Standby state : L3 is red5.3 Setting the RCU addressWhat has to be done ?To allow the communication between the RCU and the projector the RCU has to be programmed with the same address as theprojector.This address must be in the range 0–9.To know the address of the projector, one can visualize it in projection mode (on screen) as well as in standby mode (shown withthe LED’s on top cover of the projector).For more info on addresses see the appendixAt this stage the image projected may happen to be upside down or mirrored, this can be set in the Installationmenu under Projector orientation (see further setting up the projector’s orientation).Displaying the Projector Address in Standby mode1. Press the Address key (recessed key on the RCU) with a pencil.36 R59770330 SIM 7QP SERIES 08/12/2014
