6. Getting started6.3 Adjusting the imageHow to adjust the image ?1. Use the Image setting buttons on the RCUAUTAUTO IMAGEO IMAGEPCPCRGBRGBVIDEOVIDEOFire WFire WireireDVIDVIIQ-PCIQ-PCSDISDIS-VIDEOS-VIDEOPHASEPHASETINTTINTCOLORCOLORBRIGHTNBRIGHTNCONTRCONTRZOOMZOOMDIGIDIGI9 07 85 63 41 2Image 6-36.4 Switching the projector to standbyIntroductionIf the projector is not to be used for a period of time (hours, days), it is advised to switch it to standby to save energy or it can befully powered off after the cooling cycle. The advantage of standby mode compared to power off mode is the time to get it back toactive state (i.e. lamp on).After switching the projector to standby, the lamp is switched off and the cooling cycle is started (two minutes). Do not power offthe projector during the cooling cycle since doing so reduces the lamp life time.In case of SIM 7QP HB or SIM 7QP HB&C, the projector cannot be switched from active state to standby state within the first twominutes after it has been activated. Trying to do so pops up an alert message and the command is only executed after the twominutes period has expired.Image 6-4Switching to standby1. While the projector is in active state, keep the Standby button on the RCU or on the local keypad pressed for two seconds.2. The lamp is switched off and the two minute cooling cycle is started.50 R59770330 SIM 7QP SERIES 08/12/2014
