7. AdvancedThe recalibration/adjustment is explained in the procedure below.7.8.10.3.2 Calibration (for multiple projectors)What has to be done ?The calibration of Dynacolor consists of measuring the color values of each projector. The measurements have to be done in adark environment. Make sure all external lights are off (even a PC screen can produce too much unwanted light). Use a lightmeter (PR655, LMT, …) and at a fixed position during the entire measurement. In the procedure below we consider a system of 2projectors.C AUTION : Only to be done by Barco trained and qualified engineers ! Never change the values if not needed.Altered color values will not guarantee optimal image reproduction.How to calibrate Dynacolor for projector 1 ?1. Press MENU to activate the Tool bar2. Press → to select the Display setup item3. Press ↓ to Pull down the Display setup menu4. Use ↑ or ↓ to select Dynacolor5. Press → to open the menu6. Use ↑ or ↓ to select Adjust...7. Press ENTERA dialog box is displayedImage 7-1618. Press Calibrate in the Dialog boxA red full screen test pattern is displayed.9. Press ENTERR59770330 SIM 7QP SERIES 08/12/2014 139
