7. AdvancedUploading a Beta plane fileBeta planes must be uploaded in the following projector directory (accessible via FTP) :/D/display/SoftedgeThe file must be named as follows :beta.tiffThe free storage capacity on the D-drive is about 8 MB. it is needed to store the image files, geometry files, factory backup, Alphaplanes and Beta planes. Practically, about 6 MB will be available for the Alpha + Beta plane.The Beta plane will only be applied if it has been activated in the Black level... menu’s dialog box (see proce-dure below)How to activate a beta plane ?1. Press the MENU key to activate the Tool bar.2. Push the cursor key ← or → to highlight Display setup3. Push the ↓ key to pull down the menu.4. Push ↓or ↑ to select Soft edge5. Push the → key to pull down the menu.6. Push the cursor key ← or → to highlight Black level...Image 7-1407. Press ENTERA dialog box will be displayed.Black LevelInternalBeta planesPlanes Level0Image 7-1418. Use the arrows to select the Beta planes check box and press ENTERNote: It will take a certain time for the beta plane to be applied7.8.5.5 BlankingWhat can be done?Blanking or hard edging affects only the edges of the image and is used to frame the projected image on the screen and to hideunwanted image information (or noise) or to put two images next to each other without overlap (soft edge).R59770330 SIM 7QP SERIES 08/12/2014 125
