4. Installation4.7.2 Signal connectionsOverview• Input section• Input specifications• Connecting a DVI source• Connecting an RGB source4.7.2.1 Input sectionOverviewThe input section consists of 2 input layers and a communication layer:• input layer 1: twin dual link DVI input• input layer 2: analog input consisting of a 5 BNC RGBHV input, a composite video input (not supported) and a S-Video input(not supported)• communication layer: RJ45 (LAN1). This Ethernet input is connected to the image processor (PMP or Pixel Map Processor).Image 4-32Input section4.7.2.2 Input specificationsDVI input boardThis board includes two DVI dual link digital inputs. These inputs can be used separately, or they can be used as a Twin Dual DVIinput to receive a high bit depth signal (e.g. 16 bit).DVI 1 DVI 2Image 4-33Dual DVI inputVideo input boardThe video input board holds an RGBHV input. By default, the composite video (BNC connector) and the S-video input (mini-DINconnector) are not supported.R / PR G / Y B / PB Hs / Cs Vs VIDEO S-VIDEOImage 4-34Video input board4.7.2.3 Connecting a DVI sourceHow to connect two single channel DVI sources ?1. Connect each source to the projector by connecting the DVI male connector of channel 1 into the projector’s DVI 1 female inputconnector and the DVI male connector of channel 2 in the DVI 2 female input connector28 R59770330 SIM 7QP SERIES 08/12/2014
