7. AdvancedHow to select an Edit Mode ?1. When the Edit dialog box is displayed, the Select mode is selected by default.2. To go to the next mode press ENTER.3. To return to a previous mode use BACK7.8.5.3.3 Creating/editing a soft edgeDescriptionIn this example we will create an internal soft edge where we will adjust the left side zone (displace one point along the x axis).How to start up the edit dialog box ?1. Press the MENU key to activate the Tool bar.2. Push the cursor key ← or → to highlight Display setup3. Push the ↓ key to pull down the menu.4. Push ↓or ↑ to select Soft edge5. Push the → key to pull down the menu.6. Push the cursor key ← or → to highlight Edit...Image 7-1257. Press ENTERThe soft edge dialog box will be displayed.How to select the soft edge type ?The internal soft edge type is selected by default1. Push ↓or ↑ to select the Internal check box116 R59770330 SIM 7QP SERIES 08/12/2014
