4. InstallationHUBLANImage 4-39Network connection through a HUBSee Network settings to set the communication port.4.7.3.2 Network settingsC AUTION : Make sure that a DHCP server is available in the network and works fine.In normal conditions, the network detection takes few seconds. This means that the total time needed to gofrom power ON to Standby mode is only a few seconds. This value can vary depending on the speed of thenetwork connection.But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtainan IP address from the DHCP server, the startup time will be delayed by upto five minutes. After this time, atime-out occurs if the network detection fails, and the projector starts up without any network connection.What can be done?These settings are used to set the Ethernet Communication parameters.Following parameters are available :MAC Address MAC Address of the projector (This is a non-adjustable value programmed into the Ethernetboard).IP Address (Current) IP Address of the projector (This is a non-adjustable value).Subnet Mask Subnet Mask (This is a non-adjustable value)Gateway Gateway (This is a non-adjustable value)DHCP DHCP setting:• Yes: The projector will dynamically obtain its IP address from the DHCP server.• No: The IP address needs to be entered manually. Note that when selecting Fixed IPthe IP settings fields are enabledIP Address Fixed IP Address of the projector : this field can be edited when Fixed IP is selectedSubnet Mask Subnet Mask : this field can be edited when Fixed IP is selectedGateway Gateway : this field can be edited when Fixed IP is selectedHostname Hostname : this field can be edited when DHCP is selectedHow to set up the network settings ?1. Press the MENU key to activate the Menu bar.R59770330 SIM 7QP SERIES 08/12/2014 31
