3COM Security Switch 6200 Hardware and Software Users Guide 3-3Interface Connections and First Time Start-UpConnecting RemotelyTo access the system remotely:1. Connect one end of an RJ45-to-RJ45 cable into a remote access device.2. Connect the other end into the Management port. Figure 3-2 shows theManagement port module connected to a hub.Figure 3-2 Connecting to the System Remotely3. Telnet to configure IP.PowerConnectionsCAUTION: To ensure power connectivity, if you are using more than onepower supply, be sure to use separate power sources.To connect power cabling:1. Place the female end of the power cable into the power supplyconnector located on the back of the chassis. Refer to Figure 3-3 forthe exact location.Figure 3-3 System Rear View Power ConnectionsNOTE: Before applying power to the system, be sure you haveconnected a terminal or PC to the craft port. This allows you entercommands needed at startup.HubPrimary PowerSupply ConnectionSecondary PowerSupply ConnectionPower Supply AudibleAlarm Reset Button
