3-2 3COM Security Switch 6200 Hardware and Software Users GuideInterface Connections and First Time Start-UpTo connect to the serial connector use the DB9 serial connector located on thefront panel of the system.NOTE: If you are connecting to the system Management Console using aterminal or PC, the serial port on the terminal or PC must be configured for9600 baud, 8 data bits, 1 stop bit, no parity, and no flow control.Connecting a Terminal or PC to the System Front Serial CraftPortTo connect a terminal or PC to the system front serial craft port:1. Connect one end of a DB9-to-DB9 cable into the terminal or PC.2. Connect the other end into the system serial craft port. Figure 3-1shows the system connected to a laptop computer.Figure 3-1 Connecting a Laptop Computer to the system Front SerialCraft Port3. Set to VT-100 terminal emulation mode.Personal ComputerFIBER10/100/100010/100CONSOLE(max) 9800,8,N,1PACKETLINK1 3 5 72 4 6 89 11 13 1510 12 14 16FIBERPACKETLINK17 18PWRMGMT1MGMT2SYSHDD
