Panasonic TH-55SF1HU Operating Instructions Manual

Also see for TH-42SF1HU: Operating instructions

Contents

Panasonic TH-55SF1HU Operating Instructions Manual Manual pdf 56 page image

English56■ [DIGITAL LINK mode]Switches communication method of DIGITAL LINKterminal.[Auto]:Communication method is selected automatically.[DIGITAL LINK]:Communication method is fixed to DIGITAL LINK.[Ethernet]:Communication method is fixed to Ethernet.[Long reach]:Communication method is fixed to Long reach.Modes allowing communication: Valid― : InvalidSettingsCommunication validityPicturetransmission Ethernet RS-232C100 m 150 mAutoForDIGITALLINK―For Longreach ―ForEthernet ― ― ―DIGITAL LINK ―Long reach ―Ethernet ― ― ―Note● When connected with the [Long reach]communication method, the maximumtransmission distance is 150 m. In this case, thisunit can receive the signals of up to 1080/60p(148.5 MHz).● If the communication method of the twistedpair cable transmitter is set to [Long reach], set[DIGITAL LINK mode] to [Auto]. Then, connectionis enabled with the [Long reach] communicationmethod.When connecting with the separately sold DIGITALLINK Switcher (ET-YFB200G) with the [Longreach] communication method, set [DIGITAL LINKmode] to [Long reach].● Even if [DIGITAL LINK mode] is set to [Longreach], when the twisted pair cable transmitterdoes not support the communication method of[Long reach], it will not be connected properly.■ DIGITAL LINK statusDisplay the DIGITAL LINK connection environment.Select [DIGITAL LINK status] with and press.-YY dB-XX dBDIGITAL LINK statusLINK statusHDMI statusSignal qualityMinMaxNo linkNo HDMI[LINK status]:1 of the followings will be displayed.[No link]:No LAN connection, etc.[DIGITAL LINK]:Connected to the DIGITAL LINK device by LAN.[Long reach]:Communication method is set to [Long reach] and isconnected to the DIGITAL LINK device by LAN.[Ethernet]:The PC is connected to the DIGITAL LINK / LANterminal of this product and is LAN connected.[HDMI status]:1 of the followings will be displayed.[No HDMI]:DIGITAL LINK not connected[HDMI on]:DIGITAL LINK connected[HDCP on]:HDCP supported on DIGITAL LINK[Signal quality]:It is the quantified minimum and maximum numbersof errors that have occurred. The display colours arered, yellow, or green, depending on the number.Signal quality DisplayColoursReceptionStatus-12dB or below Green Good-11 to -8dB Yellow Bad-7dB or above Red Terrible● The number is represented by yellow or red ifthe LAN cable is disconnected or the cable is notshielded.● This signal quality shows figures between thetwisted pair cable transmitter that is connected andthe display.