Panasonic TH-55SF1HU Operating Instructions Manual

Also see for TH-42SF1HU: Operating instructions

Contents

Panasonic TH-55SF1HU Operating Instructions Manual Manual pdf 23 page image

23EnglishBasic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command, theparameters, and lastly an ETX signal in that order. Ifthere are no parameters, then the parameter signal doesnot need to be sent.STX C1 C2 C3 P1 P2 P3 P4: P5 ETXStart(02h)3-character command(3 bytes)ColonParameter(s)End(03h)CommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL *** Volume 000 - 100AMT 0 Audio MUTE OFF1 Audio MUTE ONIMS None Input select (toggle)HM1 HDMI 1 input(HDMI1)HM2 HDMI 2 input(HDMI2)DL1 DIGITAL LINK input(DIGITAL LINK)DV1 DVI-D IN input(DVI-D)PC1 PC IN input (PC)VD1 VIDEO input(VIDEO)YP1COMPONENT input(COMPONENT/RGB IN)UD1 USB input (USB)DAMNone Screen mode select(toggle)ZOOM Zoom1FULL 16:9NORM 4:3ZOM2 Zoom2LID:MOD0 [LightID]: [Off]1 [LightID]: [Externalcontrol]2 [LightID]: [Internal ID]Note● If multiple commands are transmitted, be sure towait for the response for the first command to comefrom this unit before sending the next command.When sending a command which does not requireparameter, a colon (:) is not needed.● If an incorrect command is sent by mistake, thisunit will send an “ER401” command back to thecomputer.● In Standby condition (power OFF with remotecontrol), the unit responds to PON command only.● Consult your local Panasonic dealer for detailinstructions on command usage.For more details, visit the following web site.http://panasonic.net/prodisplays/