a. When an SLT user answers a call, a reorder tone is heard or no one is heard on the other end.b. When an SLT user goes off-hook, a reorder tone is heard instead of a dial tone.If a call is not terminated after going on-hook, the above cases occur. To avoid these problems,choose "Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature numberis entered after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.• Hold Alarm tone pattern has a default. (® 21.2 Tones/Ring Tones)PC Programming Manual References4.5 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone→ Recall—Hold Recall→ Recall—Disconnect after Recall4.9 [2-6-1] Numbering Plan—Main—Features→ Call Hold / Call Hold Retrieve→ Call Hold Retrieve : Specified with a Holding Extension Number→ Hold Retrieve : Specified with a Held CO Line Number4.18 [2-9] System Options→Option 1— PT Operation—Automatic Hold by ICM / CO / ICD Group key→Option 1— PT Operation—Hold Key Mode→Option 5— SLT—SLT Hold ModePT Programming Manual References[200] Hold Recall TimeOperating Manual References1.3.6 Call Hold3.1.5 Call Log, IncomingDescriptionWhen a call containing Caller ID information is received by an extension, the information is shown on thetelephone display, notifying the extension user of the caller’s identity. This information is also automaticallylogged in the Incoming Call Log of the extension, and can be viewed later or used to call that caller back.Each extension and incoming call distribution (ICD) group has its own Incoming Call Log.Call Log ButtonThe Call Log button will alert an extension user to any missed (unanswered) calls. A flexible button can becustomized as the Call Log button, and will indicate the status of the Incoming Call Log for the extension orcorresponding ICD group, as shown below.Light pattern Status of the corresponding call logRed on There are call records in the log which have not been viewed.Off There are no new call records in the log.38 Feature Manual Document Version 2009-123.1.5 Call Log, Incoming
