NoteBefore recording a Two-way telephone conversation, you should inform the other party that theconversation will be recorded.14. VPS Data Control by the PBX*1The date and time settings of the VPS are controlled by the PBX.15. Remote FWD Setting by the VM*1Extension FWD settings can be programmed using the VPS.*1 This feature may not be supported depending on the software version of the VPS.Conditions[General]• When programming a KX-TVA series VPS, if there is no option to connect to a KX-TDE100/KX-TDE200PBX, select the KX-TDA100/KX-TDA200 PBX.• Voice Mail (VM) Transfer ButtonA flexible button can be customized as the Voice Mail (VM) Transfer button with the floating extensionnumber of the VM group as the parameter.[Live Call Screening (LCS)]• This feature is not available for SIP extensions.• If an SLT is connected in parallel to a PT, and if LCS is activated for the PT in Private mode, both the PTand SLT can be used to monitor calls while in idle status. The SLT will ring to indicate a message is beingrecorded. The call can be monitored with the SLT by going off-hook. To intercept the call, press the FLASH/RECALL button or flash the hookswitch. (® 13.1.2 Paralleled Telephone)• LCS ButtonA flexible button can be customized as the LCS button.• Extension Personal Identification Number (PIN)To prevent unauthorized monitoring, it is recommended the LCS user assign an extension PIN. This PINwill be required when setting LCS (® 5.1.6 Extension PIN (Personal Identification Number)). If the userforgets the PIN, it can be cleared by an extension assigned as the manager.• Each extension can be programmed to either end recording or continue recording the conversation afterthe call is intercepted, through personal programming (LCS Mode Set [After Answering]).® 6.1 [4-1-1] Wired Extension—Extension Settings—Option 4— LCS Recording Mode® 6.10 [4-2-1] Portable Station—Extension Settings—Option 4— LCS Recording Mode• To use the LCS feature on a PS in Wireless XDP Parallel Mode, LCS can only be turned on or off from thewired telephone. In Wireless XDP Parallel Mode, setting LCS on/off from the PS has no effect. (®20.1.5 Wireless XDP Parallel Mode)[Two-way Recording into the VPS]• Two-way Record/Two-way Transfer ButtonA flexible button can be customized as the Two-way Record or the Two-way Transfer button. An extensionnumber can be assigned to the Two-way Transfer button so that it can be used as a one-touch recordbutton for the mailbox of the specified extension. (One-touch Two-way Transfer Button).• When all of the VPS ports are busy:a. Pressing the Two-way Record button sends a warning toneb. Pressing the Two-way Transfer button followed by an extension number sends a warning tone.[Transferring to a Mailbox of the VPS]• When transferring a CO line call to a mailbox of the VPS, users should use the VM Transfer button.If using a standard Transfer button, users must dial "#6" after accessing the VPS, and confirm that thedesired mailbox has been reached, before going on hook to complete the transfer.Document Version 2009-12 Feature Manual 34919.1.4 Voice Mail DPT (Digital) Integration
