Honeywell 6272CV User Manual

Contents

Honeywell 6272CV User Manual Manual pdf 47 page image

Setup (Cont'd)47User SetupEach user must be assigned a name with a corresponding 4-digit usercode in order to gain access to various features and functions. TheTouchCenter can hold the identity for 10 Users in its memory. Ifadditional Users are needed, define the additional Users using theConsole Emulation Mode.Users for the system are programmed in a central user setup locationthat provides the specific questions for authorization levels assignedto different users. You may want these users to be the same, butthere are situations in which you may want a user to have limitedcapabilities. These capabilities are defined by the Authority Levelassigned each user.Authority LevelsAuthority levels define the system functions a particular user canperform. Depending on the authority assigned to you, there arecertain system functions you may be prohibited from performing. Thefollowing information describes the authority levels that can beassigned through the TouchCenter and provides the equivalentauthority level name that you will find if you are reading your alarmsystem manuals. The authority levels that can be assigned throughthe TouchCenter are as follows:Equivalent System NameTouch-CenterAuthorityLevelFunctions ResidentialSystemsCommercialSystemsMaster Can perform all security functions,add/delete users in assignedpartition, program scheduled events,and change partition master codePartitionMasterLevel 1MasterNormal Perform security functions (arm,disarm)StandardUserLevel 3Operator AGuest Can arm the system in assignedpartitions, but cannot disarm thesystem unless the system was armedwith this code.Note: Do not assign this level ifQuick Arm is enabled in your system.Guest Level 4Operator BNoAccessUsed to restrict access from apartition.N/A N/A