Chapter 2. CPU Features & Specifications60 PACSystems* RX7i, RX3i and RSTi-EP CPU Reference Manual GFK-2222ADReplacement of CPE400 Mounting BracketWhen shipped, the CPE400 is attached to the DIN-rail mounting bracket. The panel-mount bracket issupplied in the shipping carton, unattached. If the application requires panel-mounting rather than DIN-Rail mounting, exchange the mounting brackets, as follows.1. Using a T10 TORX screwdriver, remove the four machine screws (Figure 16) that secure the DIN-Rail Mounting Bracket to the CPE400 chassis.2. Keep the DIN-Rail Mounting Bracket and its four screws together in case of future need;otherwise discard.3. Install the panel-mount bracket as shown in Figure 17, using the four machine screws suppliedwith that bracket. Note that the closed eyelet is towards the top of the chassis.4. Using a T10 TORX screwdriver, torque these four machine screws to 0.6Nm (0.44 ft-lbs) in orderto securely attach the bracket to the CPE400 chassis.5. If reversing the bracket switch, note that each bracket requires its own set of machine screws.Torque requirements are the same.Figure 16: DIN-Rail Mount Bracket AssemblyCPE400Figure 17: Panel-Mount Bracket Assembly CPE400
