Messages regarding printheadsCannot adjust printhead. ................................................................................................................................ 827Wrong printhead. ............................................................................................................................................ 827Printhead error ................................................................................................................................................ 827No printhead ................................................................................................................................................... 828Execute printhead cleaning. ........................................................................................................................... 828Cannot adjust printhead.Cause Corrective ActionThe Printhead noz-zles are clogged.Execute Head Posi. Adj. again, as follows.1. Press the OK button to clear the error.2. Print a test pattern to check the nozzles.(See "Checking for Nozzle Clogging.") →P.7403. Clean the Printhead if the nozzles are clogged.(See "Cleaning the Printhead.") →P.7414. Execute Head Posi. Adj. again.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")→P.619The Printhead can-not be aligned; high-ly transparent film isloaded.Press the OK button to clear the error.We recommend using a type of paper that you often use, other than film, for Printhead adjust-ment.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).") →P.619The Printhead is in-stalled crooked.Straighten the Printhead as follows, and then execute Head Posi. Adj. again.1. Press the OK button to clear the error.2. Use Head Inc. Adj. to adjust the angle of inclination of the Printhead.(See "Adjusting Line Misalignment (Head Inc. Adj.).") →P.6233. Execute Head Posi. Adj. again.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")→P.619Wrong printhead.Cause Corrective ActionAn incompatible Printhead has been installed. Open the Top Cover and replace the Printhead with a new one.(See "Replacing the Printhead.") →P.742Printhead errorCause Corrective ActionThere is a problem with the Printhead. Open the Top Cover and replace the Printhead with a new one.(See "Replacing the Printhead.") →P.742Error Message > Messages regarding printheads >iPF650 Cannot adjust printhead.12827
