HP-GL/2 problemsWith HP-GL/2, printing is misaligned .............................................................................................................. 800Lines or images are missing in printed HP-GL/2 jobs. ................................................................................... 800Lines are printed too thick or thin in HP-GL/2 print jobs ................................................................................. 800HP-GL/2 jobs are printed in monochrome (or color) ...................................................................................... 801Printed colors of lines are inaccurate during HP-GL/2 printing ...................................................................... 801HP-GL/2 jobs are printed 6 mm larger than specified .................................................................................... 801HP-GL/2 jobs are printed at maximum size, even if a standard size is specified .......................................... 801HP-GL/2 printing takes a long time ................................................................................................................. 801Replotting with HP-GL/2 jobs is not possible. ................................................................................................. 802The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................................. 802With HP-GL/2, printing is misalignedCause Corrective ActionThe plotter origin is incorrect. Check the printing commands.The Margin setting in the Control Panel menu is incor-rect.Adjust the Margin setting values in the Control Panelmenu.Lines or images are missing in printed HP-GL/2 jobs.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printer was re-ceived.Check the print job and settings.The printer has received print data that includes HP RTL com-mands when Auto Rotate is On in the Control Panel menu.In the Control Panel, set Auto Rotate to Off andprint again.(See "Menu Settings.") →P.674Lines are printed too thick or thin in HP-GL/2 print jobsCause Corrective ActionThe Width setting in theControl Panel menu is in-correct.Check the Width setting value specified for Pen no. in Palette A or Palette B in theControl Panel menu. If fine lines are printed faintly, setting ThickenFineLines to Onwill print the lines more distinctly.(See "Menu Settings.") →P.674Troubleshooting > HP-GL/2 problems >With HP-GL/2, printing is misaligned iPF65011800
