Insufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount ofroll paper left when ManageRemainRoll in the Control Panelmenu is On.Press ▲ or ▼ to select Print, and then press theOK button to resume printing.However, the roll paper may run out during theprint job and you may not be able to print all of thedocument.Press ▲ or ▼ to select Change Paper, and thenpress the OK button to stop printing.Either change the printer driver Paper Source set-ting or the GL2 Settings > Paper Source settingin the printer menu or replace the roll with a rollthat has enough paper for the print job, and then tryprinting again.(See "Removing the Roll from the Printer.")→P.585(See "Loading Rolls in the Printer.") →P.579This paper cannot be used.Cause Corrective ActionPaper smaller than the printer's minimum suppor-ted size has been loaded.Push the Release Lever back and load paper of the correct size.(See "Paper Sizes.") →P.569Paper has been loaded that is too small to print thetest pattern for printhead adjustment or nozzlechecking.Push the Release Lever back and load unused paper of A4 size orlarger. More than one sheet may be required depending on the ad-justment.Roll printing is selected.Cause Corrective ActionYou have attempted to print a test print sheetor other printer status information on a roll,but no roll is loaded.Press ▲ or ▼ to select Load Roll Paper, and then press the OK but-ton. Load the roll, and then print.(See "Attaching the Roll Holder to Rolls.") →P.575(See "Loading Rolls in the Printer.") →P.579To print on sheets, follow these steps.1. Press ▲ or ▼ to select Stop Printing, and then press the OK but-ton to stop printing.2. Load a sheet and try printing again.(See "Loading and Printing on Sheets.") →P.9Error Message > Messages regarding paper >Insufficient paper for job iPF65012816
