Cause Corrective ActionThe Printhead is set too high in theControl Panel menu.(See "Troubleshooting Paper Abrasion and Blurry Images (HeadHeight).") →P.626The type of paper specified in theprinter driver does not match the typeloaded in the printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.579(See "Loading Sheets in the Printer.") →P.602Make sure the same type of paper is specified in the printer driver as you haveloaded in the printer.1. Press the Stop button and stop printing.2. Change the type of paper in the printer driver and try printing again.The contrast becomes uneven during printingCause Corrective ActionThe paper feed amount is out of adjust-ment.Adjust the feed amount.(See "Adjusting the Feed Amount.") →P.628The type of paper specified in the printerdriver does not match the type loaded inthe printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.579(See "Loading Sheets in the Printer.") →P.602Make sure the same type of paper is specified in the printer driver as youhave loaded in the printer.1. Press the Stop button and stop printing.2. Change the type of paper in the printer driver and try printing again.The length of printed images is inaccurate in the feeding directionCause Corrective ActionIn the Control Panel menu, Adj. Priorityis set to Print Quality.Set Adj. Priority to Print Length in the Control Panel menu, and then ex-ecute Adjust Length.(See "Adjusting the Feed Amount.") →P.628The type of paper specified in the printerdriver does not match the type loaded inthe printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.579(See "Loading Sheets in the Printer.") →P.602Make sure the same type of paper is specified in the printer driver as youhave loaded in the printer.1. Press the Stop button and stop printing.2. Change the type of paper in the printer driver and try printing again.Images are printed crookedCause Corrective ActionIn the Control Panel menu, Skew Check Lv. is set toLoose or Off.In the Control Panel menu, set Skew Check Lv. to Stand-ard.Troubleshooting > Problems with the printing quality >iPF650 The contrast becomes uneven during printing11793
