Configuring the Printer's NetWare Network Settings With RemoteUIFollow the steps below to configure NetWare protocol settings other than the frame type by using RemoteUI.Note• For details on RemoteUI, see "Using RemoteUI." →P.6971. Start the web browser and enter the following URL in the Location (or Address) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.6. Refer to the NetWare Settings Items table to complete the settings.NetWare Settings ItemsItem Details Default Set-tingFrame Type Specify the type of frame to use in NetWare. DisabledNCP Burst Mode Activate this setting to use NCP Burst Mode.This mode supports fast data transfer when printing in queueserver mode. Normally, leave the setting On.OnPrint Application Choose the print service.The print service selected here is enabled. Multiple print servicescannot be enabled simultaneously.• Bindery PServer• RPrinter• NDS PServer• NPrinterNDSPServerPacket Signature Select If Requested by Server to use packet signature. If Re-questedby ServerBindery PSer-verFile ServerNameSpecify the name of a file server that has a NetWare print server.(0–47 characters)—Print ServerNameSpecify the name of a NetWare print server.(0–47 characters)—Print ServerPasswordSet a password for the print server.(0–20 characters)—Polling Interval Specify the interval to confirm jobs. 5Network Setting > NetWare Settings >iPF650 Configuring the Printer's NetWare Network Settings With RemoteUI9717
