"Manually rewind the roll all the way and press OK."Cause Corrective ActionA paper jam occur-red when advancingthe paper.1. Rewind paper on the Roll Holder manually, all the way, and then press the OK button.2. Load the paper.3. If "Not finished printing. Finish printing remaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the page on which the error occurred.(See "Loading Rolls in the Printer.") →P.579Paper is crooked.Cause Corrective ActionPaper loaded crooked was detected when the paper was ad-vanced.Follow these steps to reload the roll.1. Push the Release Lever back.2. Adjust the right edge of the roll to make it parallelto the orange Paper Alignment Line.3. Pull the Release Lever forward.(See "Loading Rolls in the Printer.") →P.579If this error recurs after you reload the roll, removethe Roll Holder from the printer, push the roll firmlyin until it touches the Roll Holder flange, and reloadthe Roll Holder in the printer.(See "Attaching the Roll Holder to Rolls.")→P.575Follow these step to reload a sheet.1. Push the Release Lever back.2. Pull out the sheet.3. Pull the Release Lever forward.4. Reload the sheet, aligning it with the guide on theright.(See "Loading Sheets in the Printer.") →P.602Important• To disable this message (if it is displayed repeatedly despite reloading paper, for example), choose Off orLoose in the Skew Check Lv. setting of the printer menu. However, this may cause jams and printing prob-lems because paper may be askew when printed. Also, the Platen may become soiled, which may soil theback of the next document when it is printed.Error Message > Messages regarding paper >iPF650 Paper is crooked.12819
