Paper is not cut neatlyCause Corrective ActionThe paper is bent or curled at the cut posi-tion.Straighten out any curling by the edges of the paper.Paper rises by the ends of the cut position be-fore it is cut.Reload the paper correctly.You are using paper that cannot be cut withthe Cutter Unit.Specify Manual in Cutting Mode in the Control Panel menu and usescissors or a cutting tool to cut the roll after printing.(See "Specifying the Cutting Method for Rolls.") →P.594Cut Speed is not configured correctly in theControl Panel menu.Change the Cut Speed setting in the Control Panel menu.(See "Menu Structure.") →P.664During cutting, printed documents fall out atan angle.In the Control Panel menu, set Cutting Mode to Eject. Hold docu-ments after printing, as they are cut.(See "Specifying the Cutting Method for Rolls.") →P.594Paper is not cutCause Corrective ActionIn the printer driver, No or Print Cut Guideline isspecified in Auto Cut.Specify Yes in Auto Cut in the printer driver.In the Control Panel menu, Cutting Mode is set toEject or Manual.If the Cutting Mode is Eject, press the Cut button to cut the pa-per.If the Cutting Mode is Manual, cut rolls with scissors or thelike.Depression on the leading edge is leftCause Corrective ActionKeeping a roll in the printer for a longtime without printing on it may leave adepression on the leading edge.When printing quality is most important, we recommend setting Tri-mEdge Reload to On or Automatic so that the paper edge is automatical-ly cut before printing.(See "Menu Structure.") →P.664The size of clear film cannot be detectedCause Corrective ActionThe Platen is soiled with ink or other substances. Open the Top Cover and clean the entire Platen.(See "Cleaning Inside the Top Cover.") →P.757Troubleshooting > Problems Regarding Paper >Paper is not cut neatly iPF65011782
