Cause Corrective ActionWhen Detect Mismatch in the Control Panel menu isset to Pause or Hold Job, the width of the loaded rolldoes not match the width specified in Fit Roll PaperWidth in the printer driver.Follow these steps to replace the roll to match the width specified in theprinter driver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.352(See "Removing the Roll Holder from Rolls.") ➔ P.3562. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") ➔ P.342(See "Loading Rolls in the Printer.") ➔ P.345The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you se-lect Fit Roll Paper Width in the printer driver matches the width of the rollloaded in the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload thepaper.(See "Loading Rolls in the Print-er.") ➔ P.345(See "Loading Sheets in the Print-er.") ➔ P.369If "Not finished printing. Finish printingremaining jobs?" is displayed on the Dis-play Screen, press the OK button.Printing will resume, starting from the pageon which the error occurred.If this error recurs after you reload the roll,remove the Roll Holder from the printer,push the roll firmly in until it touches theRoll Holder flange, and reload the RollHolder in the printer.(See "Attaching the Roll Holder toRolls.") ➔ P.342Because the Platen is soiled with ink or other substances, the size of the clear filmcannot be detected.Open the Top Cover and clean the entirePlaten.(See "Cleaning Inside the Top Cov-er.") ➔ P.591Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left when Man-ageRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, and thenpress the OK button to resume printing.However, the roll paper may run out dur-ing the print job and you may not be ableto print all of the document.Press ▲ or ▼ to select Change Paper,and then press the OK button to stopprinting.(See "Removing the Roll from the Print-er.") ➔ P.352(See "Loading Rolls in the Print-er.") ➔ P.345Press ▲ or ▼ and select Stop Printing orpress the Stop button to stop printing.Paper size not detected. iPF840User's GuideError Message Messages regarding paper640
