Cause Corrective ActionWhen Detect Mismatch in the Control Pan-el menu is set to Pause, the type of paperloaded does not match the type specified inthe printer driver.Follow these steps to ensure the paper type matches on the printer and in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.2. Replace the loaded paper with paper of the type and size you have specified inthe printer driver.(See "Loading and Printing on Rolls.") ➔ P.18(See "Loading and Printing on Sheets.") ➔ P.21Press ▲ or ▼ to select Print, and then press the OK button to resume printing.However, note that this error may cause paper jams and affect the printing quality.The paper is too small.The paper is too small.Cause Corrective ActionWhen Detect Mismatch in the Control Panelmenu is set to Pause or Hold Job, papersmaller than the size specified in the printerdriver is loaded.Press ▲ or ▼ to select Print, and then press the OK button to resume printing.However, note that this error may cause paper jams and affect the printing quality.Adjust the paper size setting in the printer driver to match the size loaded in theprinter as follows.1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.2. Change the paper size setting in the printer driver to the size loaded in theprinter and try printing again.Replace the loaded paper with paper of a size that matches the size setting in theprinter driver as follows.1. Press ▲ or ▼ to select Change Paper, and then press the OK button to stopprinting.2. Replace the loaded paper to match the settings in the printer driver and tryprinting again.(See "Loading and Printing on Rolls.") ➔ P.18(See "Loading and Printing on Sheets.") ➔ P.21When Detect Mismatch in the Control Panelmenu is set to Warning, paper smaller than thesize specified in the printer driver is loaded.You can continue to print, but note that this error may cause problems in the print-ing results.The paper is too small.The paper is too small."Replace paper with A4/LTR (vertical) or larger"Cause Corrective ActionThe loaded paper is too small.(When you have attempted to print a testprint sheet or other printer status informa-tion.)Replace the paper with paper of A4/Letter (vertical) size or larger as follows.1. Press ▲ or ▼ to select Change Paper, press the OK button, and remove thepaper.(See "Removing Sheets.") ➔ P.3732. Switch to paper A4/Letter (vertical) or larger.(See "Loading and Printing on Sheets.") ➔ P.21The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button.PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menu isset to Pause or Hold Job, the width of the loaded rolldoes not match the width specified in Fit Roll PaperWidth in the printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resumeprinting.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.iPF840 The paper is too small.User's GuideError Message Messages regarding paper639
