5 Insert the Holder Stopper from the left in the Roll Holder asshown. Holding it at the position shown (b), push it firmly inuntil the flange (a) of the Holder Stopper touches the roll.Lock the Holder Stopper lever (c) by pushing it down to-ward the shaft side.Loading Rolls in the PrinterLoading Rolls in the PrinterFollow these steps to load rolls in the printer.You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders.Important• Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be advancedcorrectly when you turn the printer on.• Before loading a roll, confirm whether the inside of the Top Cover or the Ejection Guide is soiled. If soiled, werecommend cleaning in advance. (See "Cleaning Inside the Top Cover.") ➔ P.591Loading rolls in the Roll 1 (Upper) holder1 Press the Load button.2 Press ▲ or ▼ to select Roll 1 (Upper), and then press the OK button.Note• If any cut sheet has been fed, or roll paper that will not be used has been fed from Roll 1 (Upper), amessage is shown requesting you to remove it.Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.• If roll paper is loaded in Roll 1 (Upper) but Roll 1 (Upper) is not selected as the paper source, a messageasking you whether or not to change paper is displayed.Press ▲ or ▼ to select Load, and then press the OK button. Remove the paper and proceed to the nextstep.acbiPF840 Loading Rolls in the PrinterUser's GuideHandling and Use of Paper Handling rolls345
