Other MaintenanceOther MaintenancePreparing to Transfer the Printer ..................................................................................................................... 594Reinstalling the Printer .................................................................................................................................... 599Updating the Firmware ................................................................................................................................... 602Preparing to Transfer the PrinterPreparing to Transfer the PrinterTo protect the internal parts in transit, always follow these steps before transferring the printer to a new location.Refer to the Setup Guide for details on packing the printer and installing it after transfer.Important• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damagethe printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.Note• Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer(that is, when you execute the printer menu item to prepare for transfer).• Ink must be drawn into the Maintenance Cartridge before Level 2 or Level 3 printer transfer, as described in thefollowing table. Prepare the Maintenance Cartridge in advance.• Always follow the instructions of the service representative when transferring the printer under Level 3 conditions.LevelTransportand StorageIn Low Tem-perature En-vironmentsPermitted Angle of Inclination Amount of Ink toDispose ofRequiredMaintenanceCartridg-es(*1)Usage Examples1 No Lengthwise: 0–30ºRotation: 0–10º0(*2) Moving Within a Roomand Storage In RoomTemperature Environ-ments2 Yes All directions: 0–30º Approx. 700ml (20.3 fl oz)1 or 2 Transport By Vehicle3 Yes Lengthwise: 0–90ºRotation: 0–30ºApprox. 700ml (20.3 fl oz)1 or 2 Move by temporarilystanding vertically*1:This is the number of new Maintenance Cartridges required when you execute the Prep.MovePrinter menu.The number varies depending on the amount remaining in the Maintenance Cartridge being used.*2:If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, theMaintenance Cartridge needs to be replaced.Remove paper1 Disassemble and repackage the Wheeled Output Stacker by following the installation procedure in reverse.2 Remove the paper.• Rolls (See "Removing the Roll from the Printer.") ➔P.352Preparing to Transfer the Printer iPF840User's GuideMaintenance and Consumables Other Maintenance594
