Note• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/Draft.• To cancel printing the test pattern for adjustment, hold down the Stop button. When "Stop printing?" isdisplayed, press ▲ or ▼ to select Yes, and then press the OK button.8 Press ▲ or ▼ to enter the amount of discrepancy, and then press the OK button.If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value.The feed amount can be adjusted in 0.02% increments.Adjusting the Vacuum StrengthAdjusting the Vacuum StrengthWhen printing on heavyweight paper or paper that curls or wrinkles easily, if the Printhead rubs against paper, ad-justing the level of suction against paper on the Platen may improve results.Important• Paper rubbing against or becoming caught on the Printhead may jam or result in printed documents that aresoiled.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Paper tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2 Press the OK button.The Paper Menu is displayed.3 Press ▲ or ▼ to select Paper Details, and then press the OK button.4 Press ▲ or ▼ to select the type of paper, and then press the OK button.Note• When VacuumStrngth is set to Automatic, the setting value selected for the previous print job is dis-played (to the right of Automatic ) once you select the type of paper currently supplied.Note that this is not displayed if any of the following is executed.• Turning off the power• Replacing paper• Entering sleep mode5 Press ▲ or ▼ to select VacuumStrngth, and then press the OK button.6 Press ▲ or ▼ to select the desired setting value, and then press the OK button.ReadyPlain PaperOK: Paper Menu Plain PaperAdjusting the Vacuum Strength iPF840User's GuideAdjustments for Better Print Quality Adjusting the feed amount564
