Canon iPF685 Series Basic Manual

Also see for image Prograf iPF 685 Series: Setup guide User guide

Contents

Canon iPF685 Series Basic Manual Manual pdf 82 page image

7 Press ▲ or ▼ to select Automatic, Print Quality, or Print Length, and then press the OK button.Adjusting Line LengthAdjusting Line LengthTo ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust theamount that paper is advanced.There are two options in Adjust Length : AdjustmentPrint and Change Settings.• AdjustmentPrintAfter a test pattern is printed, you will measure the discrepancy based on the results of printing.• Change SettingsNo test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/Draft. Choose the mode that suits your particular printing application.• A:HighThis setting is applied when Highest or High is selected in Print Quality in the printer driver.• B:Standard/DraftThis setting is applied when Standard or Fast is selected in Print Quality in the printer driver.Note• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount AdjustmentMethod.") ➔ P.81• Use paper of the same type and size for adjustment as you will use for printing.Paper to PrepareWhen Using Rolls • An unused roll at least 10 inches wide• High-precision rulerWhen Using Sheets • One sheet of unused paper of at least A4/Letter size• High-precision rulerPerform adjustment as follows.1 Load the paper.• Attaching the Roll Holder to Rolls ➔P.12• Loading Rolls in the Printer ➔P.15• Loading Sheets in the Printer ➔P.21Important• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be comple-ted correctly unless the loaded paper matches the settings.2 On the Tab Selection screen of the Control Panel, press ◀ or▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3 Press the OK button.The Set./Adj. Menu is displayed.Adjusting Line Length iPF685 SeriesBasic GuideAdjustments for Better Print Quality Adjusting the feed amount82