HP-GL/2 problemsHP-GL/2 problemsWith HP-GL/2, printing is misaligned ................................................................................................................... 106Lines or images are missing in printed HP-GL/2 jobs. ................................................................................. 106Lines are printed too thick or thin in HP-GL/2 print jobs ........................................................................... 106HP-GL/2 jobs are printed in monochrome (or color) .................................................................................... 106Printed colors of lines are inaccurate during HP-GL/2 printing .............................................................. 107HP-GL/2 jobs are printed 6 mm larger than specified ................................................................................ 107HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ............................ 107HP-GL/2 printing takes a long time ...................................................................................................................... 107The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................... 107With HP-GL/2, printing is misalignedWith HP-GL/2, printing is misalignedCause Corrective ActionThe plotter origin is incorrect. Check the printing commands.Set Detect img size to Command priority or Detected size in the ControlPanel menu.The Margin setting in the Control Panel menu is in-correct.Adjust the Margin setting values in the Control Panel menu.Lines or images are missing in printed HP-GL/2 jobs.Lines or images are missing in printed HP-GL/2 jobs.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printerwas received.Check the print job and settings.The printer has received print data that includes HPRTL commands when Auto Rotate is On in theControl Panel menu.In the Control Panel, set Auto Rotate to Off and print again.(See "Menu Settings.") ➔ User's GuideThe plotter origin is incorrect. Set Detect img size to Command priority or Detected size in the ControlPanel menu.(See "Menu Settings.") ➔ User's GuideLines are printed too thick or thin in HP-GL/2 print jobsLines are printed too thick or thin in HP-GL/2 print jobsCause Corrective ActionThe Width setting in the Control Panelmenu is incorrect.Change the Width setting configured in Pen no. of the Palette A or Palette B selectedin the Control Panel menu.(See "Menu Settings.") ➔ User's GuideThickenFineLines in the Control Panelmenu is set to Off.If fine lines are printed faintly, setting ThickenFineLines to On will print the lines moredistinctly.(See "Menu Settings.") ➔ User's GuideThe Ln wdth correct setting in the Con-trol Panel menu is incorrect.Change the Ln wdth correct setting in the Control Panel menu.(See "Menu Settings.") ➔ User's GuideHP-GL/2 jobs are printed in monochrome (or color)HP-GL/2 jobs are printed in monochrome (or color)Cause Corrective ActionThe Color Mode setting inthe Control Panel menu isincorrect.Check the Color Mode setting in the Control Panel menu.(See "Menu Settings.") ➔ User's GuideHowever, for optimal Printhead performance, the printer consumes trace amounts of color ink evenwhen Monochrome is selected as Color Mode.With HP-GL/2, printing is misaligned iPF685 SeriesBasic GuideTroubleshooting HP-GL/2 problems106