Canon iPF685 Series Basic Manual

Also see for image Prograf iPF 685 Series: Setup guide User guide

Contents

Canon iPF685 Series Basic Manual Manual pdf 114 page image

Cause Corrective ActionThe loaded paper is too small. 1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.18(See "Removing the Roll Holder from Rolls.") ➔ User's Guide2. Replace the roll with a roll 10 inches wide or larger.(See "Attaching the Roll Holder to Rolls.") ➔ P.12(See "Loading Rolls in the Printer.") ➔ P.15The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button."Remove paper and check pap. size"Cause Corrective ActionA sheet has come out of the printer during printing. 1. Press the Release Lever back and remove the paper.2. Reload the sheet, aligning it with the guide on the right.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" isshown on the Display Screen, press the OK button.Printing will resume, starting from the page on which the erroroccurred.(See "Loading Sheets in the Printer.") ➔ P.21PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panelmenu is set to Pause or Hold Job, the width of theloaded roll does not match the width specified inFit Roll Paper Width in the printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.18(See "Removing the Roll Holder from Rolls.") ➔ User's Guide2. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") ➔ P.12(See "Loading Rolls in the Printer.") ➔ P.15The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loadedin the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loadedaskew, or warped paperhas been loaded.Follow these steps to reload the roll.1. Press the OK button and reload the paper.PaprWidth Mismatch iPF685 SeriesBasic GuideError Message Messages regarding paper114