Canon iPF685 Series Basic Manual

Also see for image Prograf iPF 685 Series: Setup guide User guide

Contents

Canon iPF685 Series Basic Manual Manual pdf 117 page image

Regular printing is selected, but a roll is loaded.Regular printing is selected, but a roll is loaded.Cause Corrective ActionA print job for printing onsheets was sent when a rollis loaded.1. Press ▲ or ▼ to select Remove Roll Paper, and then press the OK button to stop printing.2. After removing the roll, load and print on a sheet of the type and size of paper you have specifiedin the printer driver.(See "Removing the Roll from the Printer.") ➔ P.18(See "Loading and Printing on Sheets.") ➔ User's GuidePress ▲ or ▼ to select Stop Printing, and then press the OK button to stop printing.Paper jamPaper jamCause Corrective ActionA paper jam oc-curred in theprinter duringprinting.For roll paper, cut the paper on the upper side of the {Paper Feed Slot.1. Push the Release Lever back and remove the jammed paper.(See "Clearing Jammed Roll Paper.") ➔ P.84(See "Clearing a Jammed Sheet.") ➔ P.872. Load the paper.(See "Loading Rolls in the Printer.") ➔ P.15(See "Loading Sheets in the Printer.") ➔ P.213. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OKbutton.Printing will resume, starting from the page on which the error occurred.Paper is crooked.Paper is crooked.Cause Corrective ActionPaper loaded crooked was detected when the paper was advanced. Follow these steps to reload the roll.1. Push the Release Lever back.2. Adjust the right edge of the roll to make it parallel to theorange Paper Alignment Line.3. Pull the Release Lever forward.(See "Loading Rolls in the Printer.") ➔ P.15If this error recurs after you reload the roll, remove the RollHolder from the printer, push the roll firmly in until it touchesthe Roll Holder flange, and reload the Roll Holder in the print-er.(See "Attaching the Roll Holder to Rolls.") ➔ P.12Follow these step to reload a sheet.1. Push the Release Lever back.2. Pull out the sheet.3. Pull the Release Lever forward.4. Reload the sheet, aligning it with the guide on the right.(See "Loading Sheets in the Printer.") ➔ P.21Important• To disable this message (if it is displayed repeatedly despite reloading paper, for example), choose Off or Loosein the Skew Check Lv. setting of the printer menu. However, this may cause jams and printing problems be-cause paper may be askew when printed. Also, the Platen may become soiled, which may soil the back of thenext document when it is printed.iPF685 Series Regular printing is selected, but a roll is loaded.Basic GuideError Message Messages regarding paper117