7 Holding it at the positions indicated, close the RollCover.8 Pull the Release Lever forward.Roll paper cannot be inserted into the paper feed slotRoll paper cannot be inserted into the paper feed slotCause Corrective ActionThe roll paper is warped. Straighten out curls and reload the roll.Paper is jammed by the paper feed slot. Remove the jammed paper.(See "Clearing Jammed Roll Paper.") ➔ P.84(See "Clearing a Jammed Sheet.") ➔ P.87The paper source selection is incorrect. Press the Load button and select the paper source.Cannot load sheetsCannot load sheetsCause Corrective ActionThe paper source selection is incorrect. Press the Load button and select the paper source.Paper is not cut neatlyPaper is not cut neatlyCause Corrective ActionThe paper is bent or curled at the cut posi-tion.Straighten out any curling by the edges of the paper.Paper rises by the ends of the cut positionbefore it is cut.Reload the paper correctly.You are using paper that cannot be cut withthe Cutter Unit.Specify Manual in Cutting Mode in the Control Panel menu and use scissors or acutting tool to cut the roll after printing.(See "Specifying the Cutting Method for Rolls.") ➔ User's GuideRoll paper cannot be inserted into the paper feed slot iPF685 SeriesBasic GuideTroubleshooting Problems Regarding Paper92
