1) Put the steel ball into the hole of the pulley, and wind the cable four times toward theflange and then nine times in the opposite direction; thereafter, fix it in place usingthe pulley clip.2) As in w, set the mirror positioning tool between the No. 1 and No. 2 mirror mounts.3) Loosen the screw on the mirror pulley mount as in e; then, temporarily fix the cablein position on the left stay.4) Route the cable as shown in the illustration; engage t on the hook on the side plate,and engage the i on the tension plate on the lens mount.5) Tighten the screw loosened in e, and fix the cable to the left stay.6) Loosen the screws on the drive pulley once so that the tension of the scanner cableis even as in !0; then, tighten it once again.7) Fix the No. 1 mirror mount and the scanner cable fixing as in !1.8) Make adjustments so that the length of the cable is 34 ±1 mm as in o using a ruler.Figure 3-410COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 3 EXPOSURE SYSTEM3-14ScrewLosen the screw,and shift.Re-tightenthe screw.Set the mirrorpositioning toolSet screwsLoosen the setscrew to free thetotation of thepulley.Put the steel ball intothe hole in thepulley, and wind thecable nine timestoward the insideand four timestoward the outside;then, fit the pulley clip.Pulley clipSteel ball34±1mmoyur!1tq!0wei
