2. Routing the Blank Shutter CableFigure 10-2243. Positioning the Solenoid for the Primary Charging RollerLoosen the two screws used to fix the solenoid e in place, and move the solenoid inthe direction of B so that theR in Figure 10-225 is 5.5 ±0.2 mm when the joint q isbutted against a of the solenoid support plate w.Caution:Be sure to make the adjustment whenever you have replaced the solenoid.Figure 10-22510-22CHAPTER 10 TROUBLESHOOTINGCOPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Attach the spring tothe outside of thesides shutter.Slide shutter (rear)Wind 3.5 times.Slide shutter (front)a= 5.5 ± 0.22 13
