7-106Using remote control __________________________1 Call home.2 The outgoing message will be played.3 Press [#] while the outgoing message is playing. Enter your password when you hear thebeeps indicating that you should enter your password.When your password is accepted, you will hear a confirmation tone (a short series of beeps).4 The fax will now accept remote control commands (see List of remote control commands,p. 7-11).For example, press [1][1][#] to play back any telephone messages you may have received. Whenplayback has finished, press [9][9][#] to end the remote control.5 End the remote control and hang up the handset.n• A password is required to use the remote control features. However, if PIN ENTRY is set to OFF(see p. 8-6), it is not necessary to enter your password when you use the FORWARDING MSGfeature (see p. 7-12).• If you enter an invalid password, you will hear an error tone. If you enter two invalid passwordsconsecutively, the call will be disconnected.• You should enter a remote command within 20 seconds of entering your password. If more than20 seconds elapse after you enter your password and you do not enter a remote command, the callwill be disconnected.• The remote control features can be used even when the fax is set to a mode other than TAMMODE.• In FAX ONLY MODE, the outgoing message will not be played. Press [#] when the call isconnected.• In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If youhave not set a Fax/Tel message, press [#] when the call is connected.• In MANUAL MODE, press [#] if MAN/AUTO SWITCH has been set. If MAN/AUTO SWITCHis off, the fax will ring 15 times. Press [#] while the outgoing message is playing. Then, enteryour password when you hear the beeps.
