Remove the oil filter, and let theremaining oil drain. A specialwrench (available from yourdealer) is required.Make sure the oil filter gasket isnot stuck to the contacting surfaceof the engine. If it is, remove itbefore installing a new oil filter.Let the engine run for severalminutes, then check the drain boltand oil filter for leaks.Turn off the engine and let it sitfor several minutes, then checkthe oil level on the dipstick. Ifnecessary, add more oil.Install a new oil filter according tothe instructions that come with it.Make sure to clean off any dirtand dust on the contacting surfaceof a new oil filter.Put a new washer on the drain bolt,then reinstall the drain bolt.Tighten the drain bolt to:Refill the engine with therecommended oil.Engine oil change capacity(including filter):Reinstall the engine oil fill cap.Start the engine. The oil pressureindicator should go out within 5seconds. If it does not, turn off theengine and check your work.3.6.7.8.9.5.4.Changing the Engine Oil and Filter460OIL FILTER29 lbf·ft (39 N·m , 4.0 kgf·m)4.5 US qt (4.3 )Improper disposal of engine oil can beharmf ul to the environment. If youchange your own oil, please dispose ofthe used oil properly. Put it in a sealedcontainer, and take it to a recyclingcenter. Do not discard it in a trash binor dump it on the ground.11/07/20 19:00:35 31SJA670_465
