u LCD Display]6541 2 3789Figure 4.2 LCD DisplayTable 4.1 Display and ContentsNo. Name Display Content1 Operation Mode MenusMODE Displayed when in Mode Selection.MONITR Displayed when in Monitor Mode.VERIFY Indicates the Verify Menu.PRMSET Displayed when in Parameter Setting Mode.A.TUNE Displayed during Auto-Tuning.SETUP Displayed when in Setup Mode.2 Mode Display Area DRV Displayed when in Drive Mode.PRG Displayed when in Programming Mode.3 Ready Rdy Indicates the drive is ready to run.4 Data Display — Displays specific data and operation data.5FrequencyReferenceAssignment <1>OPR Displayed when the frequency reference is assigned to the LCD Operator Option.AI Displayed when the frequency reference is assigned to the Analog Input of the drive.COM Displayed when the frequency reference is assigned to the MEMOBUS/Modbus CommunicationInputs of the drive.OP Displayed when the frequency reference is assigned to an Option Unit of the drive.RP Displayed when the frequency reference is assigned to the Pulse Train Input of the drive.6 LO/REDisplay <2>RSEQ Displayed when the run command is supplied from a remote source.LSEQ Displayed when the run command is supplied from the operator keypad.RREF Displayed when the run command is supplied from a remote source.LREF Displayed when the run command is supplied from the operator keypad.7 Function Key 2(F2)FWD/REV Pressing F2 switches between forward and reverse.DATA Pressing F2 scrolls to the next display.→ Pressing F2 scrolls the cursor to the right.RESET Pressing F2 resets the existing drive fault error.8 FWD/REV FWD Indicates forward motor operation.REV Indicates reverse motor operation.4.2 Using the Digital Operator110 YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
