Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 43 page image

Phaser® 8200 Color PrinterCopyright © 2002 Xerox Corporation. All Rights Reserved. 38UNIX/Linux NetworkThis section provides installation and troubleshooting steps for UNIX and Linux: Overview — see page 38. Quick install steps — see page 38. Additional resources — see page 39.OverviewYour Phaser printer supports connection to a variety of UNIX platforms. Below is a list of the currentlysupported versions: Solaris IBM AIX Hewlett-Packard HP-UX DEC UNIX True UNIX 64 (Compaq) Linux (i386) Linux (PPC) SGIThe procedures contained in this document enable you to connect your printer using any of thesupported versions of UNIX or Linux listed above.Quick install steps1. Print the Configuration Pages and retain them for reference. For information on printingConfiguration Pages, see the Front Panel chapter of the Phaser 8200 Color Printer User Guide onthe Software and Documentation CD-ROM.1. Check the Configuration Pages and verify that both TCP/IP protocol and the proper connector areenabled.2. Go to the section IP Address and perform one of the procedures there, depending on the manner inwhich you want to set your printer’s IP address.3. Solaris: Refer to the CentreWare Services for Unix Systems User Guide (English only) includedon the Advanced Network Management Tools CD-ROM for CentreWare installation anddetailed printer setup instructions.Other UNIX OS: Load printer drivers and configure the printer for one of the Print Models.These drivers are available on the Advanced Network Management Tools CD-ROM or fromthe Xerox web site at www.xerox.com/officeprinting/support.