Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 32 page image

PhaserÆ 8200 Color PrinterCopyright © 2002 Xerox Corporation. All Rights Reserved. 27Macintosh EtherTalk Network(MacOS 8.x/9.x/X, version 10.1)This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X,version 10.1): Quick install steps for MacOS 8.x and 9.x ó see page 28. Quick install steps for MacOS X, version 10.1 ó see page 30. Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk ó see page 30. Macintosh troubleshooting step-by-step ó see page 31.Requirements A workstation with the appropriate driver installed. A working knowledge of the operating system (System 8.0+ or higher) being used on yourworkstation. Proper cabling in use to connect your printer to the network.Enabling EtherTalkIf you use EtherTalk, Macintosh computers do not require IP addresses.1. Open the AppleTalk Control Panel.2. Verify that the Ethernet port is the selected network port.3. To install the printer driver, double-click the installer on the Software and DocumentationCD-ROM.Perform the next two steps for MacOS 8.x and 9.x.1. Open the Chooser, select the LaserWriter driver.2. From the right column of the Chooser, select the printer. Click Create to create the desktopprinter.Perform the next two steps for MacOS X, version 10.1 only.1. Open Print Center.2. Click Add Printer, select the printer, then click Add.For more details, refer to the infoSMART Knowledge Base at www.xerox.com/officeprinting/infoSMART, Document #2562.