Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 21 page image

PhaserÆ 8200 Color PrinterCopyright © 2002 Xerox Corporation. All Rights Reserved. 16Windows NT 4.x NetworkThis section provides installation and troubleshooting steps for Windows NT 4.x: Preliminary steps ó see page 16. Quick CD-ROM install steps ó see page 16. Other methods of installation ó see page 17. Windows NT 4.x troubleshooting (TCP/IP) ó see page 19. Windows NT 4.x troubleshooting (AppleTalk) ó see page 20.Preliminary stepsThe preliminary steps given below must be accomplished for all printers regardless of the method that isbeing used.1. Verify that the printer is plugged in, turned on, and connected to an active network.2. Verify that the printer is receiving network traffic by monitoring the LEDís on the back of theprinter or on the CentreDirect External Print Server. When the printer is connected to afunctioning network receiving traffic, its link LED is green, and its traffic LED (amber) is flashingrapidly.3. Print the Configuration Pages and retain them for reference. For information on using the frontpanel or printing Configuration Pages, , see the Front Panel chapter of the Phaser 8200 ColorPrinter User Guide on the Software and Documentation CD-ROM.4. Check the Configuration Pages and verify that the desired protocol is enabled.5. Proceed to the Quick CD-ROM install steps or Other methods of installation section for theinstallation method desired.Quick CD-ROM install stepsThe Xerox installer for Windows is on your printerís software CD-ROM. A single integrated installer isused to install printer drivers and other software.The Xerox installer automatically performs printerinstallation tasks and creates a printer. In most cases, you are required only to make a few installationchoices, clicking Next to move from screen to screen.To install the drivers and other software:1. Insert the Software and Documentation CD-ROM into your CD-ROM drive.a. If the Windows autorun feature is enabled, the CD-ROM launches automatically.b. If the Windows autorun feature is disabled, double-click My Computer, double-click the CDicon to access the CD-ROM, then double-click startup.exe.2. Follow the on-screen instructions to complete the installation.