Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 24 page image

Windows NT 4.x NetworkPhaserÆ 8200 Color Printer 1920. Send a print job to the printer.21. Check the print job for print-quality. If print-quality problems exist or if your job did not print, seethe Phaser 8200 Color Printer User Guide on the Software and Documentation CD-ROM tocorrect the problem or access PhaserSMART from the Troubleshooting tab of your printer driver.Windows NT 4.x troubleshooting (TCP/IP)This troubleshooting section assumes you have completed the following tasks: You have loaded a Phaser printer PCL or PostScript print driver. You have printed and retained a current copy of the Configuration Pages. For information onprinting Configuration Pages, see the Front Panel chapter of the Phaser 8200 Color Printer UserGuide on the Software and Documentation CD-ROM.1. Verify these items in the TCP/IP area of the Configuration Pages: IP Address Source is set to DHCP, Front Panel, BOOTP, or Auto IP (depending on yournetwork configuration). Current IP Address is set correctly. (Note this address if it is assigned by Auto IP, DHCP, orBOOTP.) Subnet Mask is set correctly (if used). Default Gateway is set correctly (if used).The LPR setting must be enabled. Check the LPR and AppSocket settings and verify they are setas desired.2. Verify the Language in the LPR area of the Configuration Pages: Interpreters: Auto, PCL or PostScript (depending on your driver).3. Verify that the client is logged into the network and printing to the correct print queue. Also verifythat the user has access to the Phaser printer queue.4. From the server desktop, use the right-mouse button to click on Network Neighborhood. Withthe left-mouse button, select Properties from the cascade menu.5. The Network dialog should appear. Select the Protocols tab.6. Check the list of installed network protocols for TCP/IP Protocol.7. As required, click Add and install any components not listed and restart the system.8. Once rebooted, click on Start, select Settings, select Control Panel, and double-click onServices. Find TCP/IP PrintServer. Verify that the Status column reads ìStartedî and the Startupcolumn reads ìautomaticî.9. Select the Start button and Settings, then select the Printers folder. The Printers window shouldappear.10. Right-mouse-click on the printer icon and select Properties.11. Verify that you have loaded and selected the correct driver for your printer.12. Select the Ports tab.