Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 27 page image

Windows 2000/XP NetworkPhaserÆ 8200 Color Printer 22Other methods of installationYour printer can also be installed on a Windows 2000/XP network using one of these methods: Microsoft TCP/IP protocol AppleTalk protocolThe following methods can also be used to install or configure your printer: The CentreWare DP program on your Advanced Network Management Tools CD-ROM canalso be used to monitor and configure the printer. If your printer is connected to a Windows 2000/XP network with the TCP/IP protocol enabled,you can use a web browser to monitor and configure your printer through CentreWare IS. For installing or managing multiple printers on a Windows 2000/XP network with TCP/IPprotocol enabled, you can use the Xerox CentreWare MC snap-in to Microsoft ManagementConsole. Refer to the Xerox CentreWare MC User Guide on theAdvanced Network Management Tools CD-ROM.The above methods are not discussed in this section. For more information concerning CentreWare IS,CentreWare DP, or CentreWare MC, see ìPrinter Managementî on page 5.Quick install steps (Microsoft TCP/IP protocol)NoteFor Windows XP, switch to Classic Look using the Taskbar and Start Menu Propertiesdialog box. Otherwise, Windows XP procedures do not match the steps below.1. At the Desktop, right-mouse-click the My Network Places icon and select Properties.2. Right-mouse-click the Local Area Connection icon inside the Network and Dial-upConnections window. Select Properties.3. Select the General tab and verify that Internet Protocol (TCP/IP) is loaded.4. If the TCP/IP software is not present, install it using the documentation provided by Microsoft,and then return to this document.5. Open the Control Panel and double-click the Printers icon.6. For Windows 2000, double-click Add Printer; the Add Printer Wizard starts.For Windows XP, Select the Printer Tasks menu and click Add a Printer.7. Click Next>.8. Click the Local Printer radio button.9. Click Next>.10. Click the Create a New Port radio button.11. Select Standard TCP/IP Port from the New Port Type pull-down menu.12. Click Next>.13. The wizard now starts the TCP/IP port wizard, click Next>.