Windows 2000/XP NetworkPhaserÆ 8200 Color Printer 2413. You may now capture the AppleTalk Device. With this action, you prevent others from printing tothis device. In most applications it is best to select No. If you are installing the printer port on aserver that acts as a single print queue for this device, then click Yes.14. Insert your printerís Software and Documentation CD-ROM into your computerís CD-ROMdisk drive and click Have Disk.15. Click the Browse button and select the directory containing the Windows 2000/XP drivers::\instal\win2k or :\instal\winxp, and then click Open.16. Select the *.INF file, then click OK.17. The Wizard returns you to the previous dialog. Verify that the path and file name are correct, andclick OK.18. At the next dialog, enter a name for the printer and select whether you want that printer to be thedefault, and then click Next>.19. If the printer is not shared, click Next>. To share the printer, enter a Share Name, check the sharecheckbox, and then click Next>.20. At the next dialog, it is recommended that you print a test print. Click Next>.21. The Completing the Add Printer Wizard window appears. If all the data presented is correct,click the Finish button. If not, click the button to correct any errors.22. Wait for the test print to print. A new dialog asks for confirmation of the test print; click Yes.23. Send a print job to the printer.24. Check the print job for print-quality. If print-quality problems exist or if the job does not print,refer to the Phaser 8200 Color Printer User Guide on the Software and DocumentationCD-ROM to correct the problem or access PhaserSMART from the Troubleshooting tab of yourprinter driver.Windows 2000/XP troubleshooting (TCP/IP)NoteFor Windows XP, switch to Classic Look using the Taskbar and Start Menu Propertiesdialog box. Otherwise, Windows XP procedures do not match the steps below.This troubleshooting section assumes you have completed the following tasks: You have loaded a Phaser printer PCL or PostScript print driver. You have printed and retained a current copy of the Configuration Pages. For information onprinting Configuration Pages, see the Front Panel section of the Phaser 8200 Color Printer UserGuide on the Software and Documentation CD-ROM.1. Verify these items in the TCP/IP area of the Configuration Pages: IP Address Source is set to DHCP, Front Panel, BOOTP, or Auto IP (depending on yournetwork configuration). Current IP Address is set correctly. (Note this address if it is assigned by Auto IP, DHCP, orBOOTP.) Subnet Mask is set correctly (if used). Default Gateway is set correctly (if used).
