Xerox Phaser 8200 Networking Setup Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Advanced features and troubleshooting manual Installation Specifications

Contents

Xerox Phaser 8200 Networking Setup Manual Manual pdf 26 page image

PhaserÆ 8200 Color PrinterCopyright © 2002 Xerox Corporation. All Rights Reserved. 21Windows 2000/XP NetworkThis section provides installation and troubleshooting steps for Windows 2000/XP: Preliminary steps ó see page 21. Quick CD-ROM install steps ó see page 21. Other methods of installation ó see page 22. Quick install steps (Microsoft TCP/IP protocol) ó see page 22. Quick install steps (AppleTalk protocol) ó see page 23. Windows 2000/XP troubleshooting (TCP/IP) ó see page 24. Windows 2000/XP troubleshooting (AppleTalk) ó see page 25.Preliminary stepsThe preliminary steps given below must be accomplished for all printers regardless of the method that isselected.1. Print the Configuration Pages and retain them for reference.2. Verify that the printer is plugged in, turned on, and connected to an active network.3. Verify that the printer is receiving network traffic by monitoring the LEDís on the back of theprinter or on the CentreDirect External Print Server. When the printer is connected to afunctioning network receiving traffic, its link LED is green, and its traffic LED (amber) is flashingrapidly.4. Proceed to the Quick CD-ROM install steps or Other methods of installation sections for theinstallation method desired.Quick CD-ROM install stepsThe Xerox installer for Windows is on your printerís software CD-ROM. A single integrated installer isused to install printer drivers and other software.The Xerox installer automatically performs printerinstallation tasks and creates a printer. In most cases, you are required only to make a few installationchoices, clicking Next to move from screen to screen.To install the drivers and other software:1. Insert the printerís software CD-ROM into your computerís CD-ROM drive.a. If the Windows autorun feature is enabled, the CD-ROM launches automatically.b. If the Windows autorun feature is disabled, double-click My Computer, double-click the CDicon to access the CD-ROM, then double-click startup.exe.2. Follow the on-screen instructions to complete the installation.