Connecting Hardware Devices Installing extended depth devices 81Installing extended depth devicesThis section provides instructions for installing devices in the 5.25-inch device bay thatare longer than standard optional devices. The following procedure demonstrates how toinstall an auto loader.1 If the server is in operation, shut it down. Then remove the access panel. Fordetailed instructions, read steps 1 through 5 in Maintenance overview on page 53.2 Complete one of the following steps:❖ If your server is equipped with an EPS power supply, proceed to step 7.❖ If your server is equipped with an EPS-R power supply, remove the exhaust fanmodule (see Removing and replacing the primary exhaust fan on page 60), thengo to step 3.3 Remove the seven screws securing the power supply cover plate to the EPS-R cageand server chassis.Removing the power supply cover plateCAUTION: Installing devices with the power on may damage the server and device.HINT: Notice that the four screws securing the cover plate to the EPS-R cage andthe three screws securing the cover plate to the server chassis are different sizes.
