Connecting Hardware Devices Memory modules 69Removing a memory module1 If the server is in operation, shut it down. Then remove the access panel. Fordetailed instructions, read steps 1 through 5 in Maintenance overview on page 53.2 Press the levers securing the memory module away from the module, then lift thememory module from the connector.Removing a memory module3 If necessary, rearrange the memory modules so that the first module is in the lowestnumbered memory slot—starting with slot 1 through slot 4. If the memory modulesare of different capacities, place them in order of increasing capacity. Install thememory module with the smallest capacity in slot 1.4 Replace the memory slot cover, if available.5 Reinstall the access panel, reconnect all signal and power cables, then turn on theserver. For instructions, read steps 7 through 10 in Maintenance overview on page53.CAUTION: Removing a memory module while the server is on could cause damageto the server or the memory module.Memory modules can be seriously damaged by static electricity. Wear a wrist orheel ground cable to discharge static electricity carried on your body. If suchequipment is not available, touch a grounded metal object to discharge staticelectricity before working on sensitive electronic components.HINT: Handle the module with care. Occasionally, the memory module may pop outwhen you open the latches.
